– ITS STEP –
In this article we utilize motherboard “ ECS ” type:= P4M800PRO M3 for example.
Phase 1. Cooler's CPU and CPU Assembly.
Phase 2. Memory's Assemblies.
Phase 3. Motherboard's Assemblies.
Phase 4. IDE Assembly / SATA / FDD Devices.
Phase 5. Casing And's Assemblies Power Supply's Assemblies.
Phase 6. Expansion Card's Assemblies.
Phase 7. power's Cable Layings and Link.
Phase 8. Pane Cadre Assemblies Header.
Phase 9. Cable Layings on CPU
** Don't Link / Turns On electricity before all rigged with every consideration ***
Step 1. and's CPU Assembly Cooler's CPU.
1.1. Intel Pentium's assembly 4 LGA775 CPUS.
—-1.1.A. processor's tide on aught hole considerably neglectless
1.2. Cooler's CPU assembly
Step 2. Memory's Assemblies.
—-2.2. memory's assembly one way, so may not flip over, assemble cautiously.
Step 3. Motherboard's Assemblies.
—-3.2. Open plate that is at rear end, so mother boardnya can be assembled.
—-3.3. motherboard's tide with every consideration and don't forget available bolt who shall at tide
Step 4. IDE Assembly / SATA / FDD Devices.
——-4.1.1. cover casing's open fore.
——-4.1.2. 5.25 fairish plastic open? in front casing.
——-4.1.3. Insert and optical drive's tide, don't forget to be bolted.
—-4.2. Disk Drive Floppy assembly.
——-4.2.1. FDD'S tide goes to slot and be bolted
—-4.3. and SATA Hard Drives's IDE assembly
——-4.3.1. hard drive's tide in casing and don't forget to be bolted.
Step 5. Power Supply's preparation and Assembly.—-5.1. Second open nurginal casing and power supply's tide in place.
—-5.2. Accelerate power supply by bolts.
Better utilizes fairish power supply 300W or more. If electricity current less can cause system's job unstable.
Step 6. Expansion Card's Assemblies.
—-6.1. Utilize expansion card would be convenient with motherboard.
—-6.2. Plate open, then inserts expansion card.
—-6.3. Assemble expansion card (pressed until aptly comes in) then is bolted
Step 7. Cable Layings and Power Connector.
–ATX power connector: link with ATX Connector on motherboard.
–ATX_12V power connector: link with ATX_12V on motherboard.
–power connector's IDE: link with device's IDE.
–FDD power connector: link with FDD Device.
–SATA power connector: link with SATA Device.
—-7.2. power supply's connective accords its couple. (as example of image upon).
—-7.3. Back tide each casing, then is bolted.
Stain:
1. power connectors's cable and connectors's audio is designed just can be utilized for one way.
2. After IDE / SATA Hard is assembled, insert BIOS and does penyetingan.
Step 8. Connecting The Header's Pane Cadre.
FP PWR / SLP: Message / Power / Sleep LED.
PWR_SW_P / N: Power Switch.
HD_LED_P / N: Hard Drive Activity LED's IDE
RST_SW P / N: Reset Switch
Step 9. Ports's Assemblies on casing.
After all is assembled, then keyboard's connective, the mouse, monitor, etc.. Turn the computer on and install is systemnya's software.
Komentar :
Posting Komentar